FPGA and Configuration Modules
- Stratix® 10 SX 2.8MLE with ARMV8 (Integrated quad-core 64 bit ARM CortexA53 hard processor system up to 1.5 GHz embedded)
- MAX10 CPLD with board management control
- JTAG connector for external USB cable
- eMMC 32GBytes (HPS) / with U-boot, Linux kernel & Rootfs
- NOR Flash for quad SPI (x4) FPGA configuration mode
Memory
- 4 DDR4 memory banks on board:
- 3x banks 16GB + ECC, x72bit (FPGA) Up to 2400MT/s
- 1x bank 8GB + ECC, x72bit (either HPS or FPGA)
@2400MT/s (if HPS not used) or @1866MT/s (if HPS is used)
Communication Interfaces
- Ethernet 10/100/1000 Base-T (HPS)
- 4x 10GbE base KR (default)
- 2x Serial SATA revision 3.0, 6Gb/s
- 4x XCVR lane connected to extension connector (DisplayPort/SDI capable)
- 3x USB2.0 HOST
- 1x USB3.0
- 1x SMB,I²C,UART
- 8 GPIOs (4 FPGA + 4 HPS)
- 2x PCI Express x16 (Gen 1, 2 or 3), root complex, end-point supported
- eSPI interface multiplexed over Intel Low Pin Count (LPC) Interface
- Network Controller Sideband Interface (NC-SI) supported (and optional)
Other resources
- Extension connector : Interfaces (4x transceivers Rx/Tx and 4xLVDS interface)
- Programmable PLL (Si5341), output clocks frequency 0.0001MHz to 750MHz
- High precision on board oscillator, clock accuracy 20MHz-0.05ppm for Precision Time Protocol (PTP) IEEE 1588
Power
- +12V primary power supply input, 120W max
- +5V standby and 3.3V RTC power supply inputs
- Delivered with a custom heatsink
Operating Range : 0°C to 40°C
Storage temperature Range : 0°C to 70°C
Board Dimensions
- Length : 125mm (4.92inches)
- Width : 95mm (3.74 inches)
- Height (without heatsink) :
- 11.91mm (with 5mm Standoffs)
- 14.91mm (with 8mm Standoffs)
Standards and compliance
- RoHS/REACH compliant
- UL certified
- ISO9001 Facility